WCA360M Low-Cost Single Axis Tilt Sensor for Solar Tracking and Tower Crane Monitoring

WCA360M single axis tilt sensor is a new low-cost tilt measurement product. Adopting the latest anti-interference platform design, integrating new micro-mechanical sensing unit, wide temperature working performance, excellent anti-vibration performance, stable and reliable long-term work, and effective working life of up to 10 years. This product uses a non-contact principle to measure the tilt angle of an object, and calculates the real-time tilt angle by measuring the component produced by the earth's gravity through an internal capacitive micromechanical unit. The installation is simple and convenient, and it only needs to be fixed on the object to be tested, and does not need to fix the shaft and the rotating shaft. A variety of installation methods to meet customer measurement needs. It is an ideal accessory for engineering machinery, agricultural machinery, and other industrial equipment.

• Resolution 0.1°
• Wide voltage input 9~36V
• Output Surge Protection
• output method RS485(MODBUS)
• IP67 Protection Class·
• Wide temp work-40°C~+85°C
• Input Overvoltage And Overcurrent Protection

• Solar photovoltaic tracking system
• Hospital bed·
• Wind deviation monitoring ·
• Woodworking machinery.
• Electric vehicle control·
• Building tower crane
• Vertical monitoring

1. The Working Principle Is Sensing Gravity Of Earth, When Installation, The Sensing Axis Of The Sensor Should Be Parallel With The Tilt Axis Of Measured Object To Achieve The Best Accuracy. The Install Surface Of The Measured Object Must Be Flat, Stable, Contact Close. Error May Be Caused If The Installation Surface Is Not Even.
2. The Protection Class Is IP67, Rain Or Water Spray Would Not Affect Its Proper Work, Please Do Not Soak It Under Water For Long Time In Case Inner Circuit Would Be Damaged, Damage Caused By Which Is Beyond Warranty Service.
3. After Installation, Please Do Not Short Circuit Signal Wire And Power In Case Of Damaging Output Circuit The Signal And Power Is Shared By The Same Wire, So Please Connect Acquisition Signal- End To The Power-